Set the classification result to 100%

If you use the Complete document (hierarchical) classification mode, it is possible, due to the different types of classification used, that the final classification result can have a very low confidence, even though it is correct. This can happen when subtree classification is used, or the default classification result is applied.

You can set the final classification result to 100% by following these steps:

  1. Open the locator properties.
  2. On the General tab, in the Classification Mode group, select Complete document (hierarchical) classification mode.
  3. In the Classification Settings group, select Set classification result to 100%.
  4. Open a test document and click Test to test your settings.
  5. Optionally, click Close to close the locator properties window.
  6. Save the changes to your project.