› AutoStore › Capture Components › Samsung › How to configure Samsung component settings › Managing groups › Adding and editing groups in the Samsung component

Adding and editing groups in the Samsung component

How to add a new group

The Common Group cannot be removed.
  1. Click the Groups tab and click Add Group.
  2. In Group Settings, type a name for the group in the Name box.

    This name does not appear on the MFP display as it is used strictly for identification purposes.

  3. If the MFP devices in this group should authenticate the user, click the Authentication tab, and select the Requires Authentication check box.
  4. Add the MFP devices that will be associated to this group by entering the IP Address or host name of the MFP in the Associated MFP Addresses list.

    The Asociated MFP Addresses list box must contain at least one MFP.

    The network name is preferable, because the IP address can change if you are using Dynamic Host Configuration Protocol (DHCP).
  5. Click OK.
  6. To edit an existing group, double click the group name, or click the group name and click Edit.
  7. To remove an existing group, click the group name and then click Remove.

How to enable group level authentication

  1. On the Groups tab, click the group and click Edit
  2. Click the Authentication tab and select the Requires Authentication check box.
    To use the same authentication settings that were configured for authentication globally, select the Use Global Authentication Settings box.
  3. Complete the instructions described in the Authentication topic.
  4. Click the General tab.
  5. For Temporary Repository, select: Internal HTTP(S).
    The internal web server will then be used to receive scanned documents. Select the SSL option to use the SSL protocol when transmitting scanned documents to the AutoStore server.
Completing this procedure displays MFP address/Host Name values for devices.