Connect To Device Step
This step helps you connect to a remote device.
Properties
- Name
- Name of the step.
- Device
- Select the dynamic reference name you want to use. This reference name is specified in the Required Devices property of the Device Automation step. The list shows only dynamic references.
- Host
- Enter Automation Device name or IP address.
- Port
- Specify the command port to use with your Automation Device (default 49998). This port is specified in the Device Automation Service configuration.
- Token
- Specify a token name. The token must match the name specified for the selected Automation Device in the Token field on the Single User tab of the Device Automation Service configuration. The Device Automation Service must be in the Single User mode. See
- Timeout
- Specify the connection attempt timeout in seconds.
- Attempts
- Specify the number of connection attempts. Note that there is a few seconds delay between each connection attempt.