Connect To Device
This step helps you connect to a remote device.
Properties
- Name
- Name of the step.
- Device
- Select the dynamic reference name you want to use. This reference name is specified in the Required Devices property of the Call Robot step. The list shows only dynamic references.
- Host
- Enter Automation Device name or IP address.
- Port
- Specify the command port to use with your Automation Device (default 49998). This port is specified in the Desktop Automation Service configuration.
- Token
- Specify a token name. The token must match the name specified for the selected Automation Device in the
Token field on the
Single User tab of the
Desktop
Automation Service configuration.
Important The Desktop Automation Service must be in the Single User mode. See Configure the Desktop Automation Service.
- Timeout
- Specify the connection attempt timeout in seconds.
- Attempts
- Specify the number of connection attempts. Note that there is a few seconds delay between each connection attempt.