General tab - Properties of Bar Code Locator window
Use the General tab to configure how a bar code is recognized as well as the length settings.
- Bar Code Recognition Engines
-
This group has the following setting:
- Select how bar codes are recognized
-
Select one of the following methods to recognize bar codes.
-
OmniPage. (Default: Selected)
Choose this value to use the OmniPage recognition engine to detect and extract bar codes.
When this value is selected, the Settings tab is available.
-
Enhanced Bar Code.
Choose this value to use the Enhanced Bar Code recognition engine to detect and extract bar codes.
-
OmniPage and Enhanced Bar Code.
When this value is selected, the following setting is available.
- Voting behavior when locations match
-
Select one of the following methods to determine which recognition engine results are used if the bar code locations for each engine are found at the same coordinates.
-
Use OmniPage result.
When chosen, the OmniPage result is extracted rather than the Enhanced Bar Code result.
-
Use Enhanced Bar Code result.
When chosen, the Enhanced Bar Code result is extracted rather than the OmniPage result.
-
Use Both results.
When chosen, both recognition engine results are returned. The voting between the two results is then done via script.
-
-
- Length
-
This group has the following settings:
- Restrict length
-
Select this setting to eliminate any unwanted bar codes from the results. (Default: Cleared)
- Min. length
-
This setting is available only when the "Restrict length" setting is selected. Set the minimum length so shorter bar codes are excluded from the results. (Default: 5)
- Max. length
-
This setting is available only when the "Restrict length" setting is selected. Set the maximum length so longer bar codes are excluded from the results. (Default: 10)
Definitions for the buttons at the bottom of this window can be found in Common Transformation Designer Buttons.