Welcome to Help > Prepare document profiles and associated objects for production > Field profiles: Overview > Settings for field profiles > Settings for single item field profiles > Validate field data > Validate field values

Validate field values

Kofax ReadSoft Entrance validates a field after interpretation and each time the field changes value during verification. If validation fails, the field receives an error status and the Verify operator is prompted to correct the field value before the field (and the document it belongs to) are ready for further processing.

Kofax ReadSoft Entrance has many automatic validation routines. Use the Validation settings in the field profile to specify additional validations that Kofax ReadSoft Entrance should perform.

  1. Using Manager, open the document profile, make sure it is inactive, and then open the field profile.
  2. Click Validation.
  3. For validation of numeric fields, use these settings in the Field validation group box:
    • Interval From and To specifies a valid range for a numeric field. For example, type 1 and 12 to have Interpret check whether the interpreted value of the current numerical field is greater than or equal to 1 and less than or equal to 12. No decimals are allowed here.
    • Use Checksum to carry out a modulo 10 check-digit control of a numeric field.

    Additional methods of validating fields, especially when there are relationships between multiple fields:

    Notes
    • If a Verify operator tries to approve a field value on a document that does not match the validation settings or the format specification, a warning message is displayed, asking the operator to confirm or change the value. The operator can approve a value that does not match the validation settings and/or format specification.
    • Validation settings can also be applied to value identifiers. Since identifiers are used only during interpretation, you cannot adjust the Field handling in Verify, Document validation, or Table validation settings. To apply these settings to an identifier profile, copy the identifier profile to a single item field. Then, apply the settings to the new field profile.