Welcome > Use Project Builder > Test and optimizing a project > Preliminary tests > Preliminary verification testing

Preliminary verification testing

If you are including the Verification module in the workflow for this project, you can test your verification settings using Test Verification. The window that is displayed is similar to the Kofax Transformation - Verification module. Use this window to test your field-level verification settings.

Note Even if you select a single document only from your document set, all of the documents in your document subset are shown in a batch folder. Since the other documents are not yet processed, a warning is displayed if you select one of them from the Batch Content pane.

You can perform preliminary verification testing by following these steps:

  1. Open the Documents window if it is not already open.
  2. If a different view is in use, switch to the List View Documents Window - Flat View icon.
  3. Add or select the document set that contains some test documents.

    The document set expands so you can see its document subsets.

  4. Select the document subset that contains the desired test documents.

    The test documents are displayed.

  5. On the Process tab, in the Test group, click Process.

    A progress bar is displayed showing the classification and extraction progress.

  6. Open the Extraction Results window if it is not already open.

    The extraction results are displayed. Invalid fields have a blue question mark and valid fields have a green check mark.

  7. Test your validation form using Test Validation.
  8. After closing Test Validation, on the Process tab, in the Test group, click Verify.

    Alternatively, press Ctrl + F8.

    Test Verification is displayed so that you can test the behavior of your verification settings.

  9. When you are finished, from the Batch menu, select Exit.

    The Test Verification window is closed.

  10. Optionally, edit your verification settings and test again.