Recognition Profiles Window - Patch Code Engine
Use this window to set up a recognition profile that uses the patch code recognition engine.
Name
Select the name of a previously defined patch code recognition profile. The other options on the window are refreshed with the settings defined for that profile.
Engine
This is preset to Patch Code.
Left offset (inches)
Enter a value that defines a point that falls near the center of the patch code. The offset value allows the patch code engine to quickly locate the patch code on the page. It can be any value between 0 and the maximum page width.
Alternatively, you can enter a value of 0 to specify searching anywhere in the horizontal direction for the patch code.
Patch code type
Select a patch code type for which to search:
-
All patch codes
-
Patch T
-
Patch I
-
Patch II
-
Patch III
-
Patch IV
-
Patch VI
Image Cleanup
Select an image cleanup profile from the drop-down list.
Edit button
To modify an existing image cleanup profile or create a new one, click the Edit button. The Image Cleanup Profiles window appears, allowing you to specify the type of image cleanup to use, along with other advanced settings.
Delete button
Click this button to delete the currently selected profile. It is not possible to delete profiles that are built in to Kofax Capture
Script button
If enabled, use this button to assign a recognition script to the selected profile. The Recognition Script window appears, allowing you to associate a recognition script with the recognition profile.
Test button
Click this button to test your zone settings. Your recognition profile and cleanup settings are applied to the zone and the results appear in the Zone Test window.