Advanced Properties - Patch Configurator - Kodak Scanners

Use the Patch Configurator panel to assign a scanner action that occurs when a patch code (ranging from Patch 10 to Patch 15) is detected.

You can assign each of the following actions to one patch code at a time:

If an action is not assigned to a patch code, the value is listed as None.

Omit Multifeed After Patch

When this action is assigned, the following occurs:

  • The page that follows the patch sheet does not trigger a multifeed exception.

  • If imprinting is enabled, the patch sheet is not imprinted.

  • Patch sheet image is discarded.

  • Dual-controlled stacking is supported.

  • Operator panel option to omit multifeed works independently of this setting.

Omit Multifeed Toggle Patch

When this action is assigned, it works the same as Omit Multifeed After Patch, except for the following:

  • All pages that follow the patch sheet do not trigger a multifeed exception until another patch is detected, or the scanner is disabled.

  • Operator control panel option to override multifeed detection takes precedence over this setting.

Stop Scanning

When this action is assigned, the scanner is stopped when the patch code is detected so the scan operator can update settings in the application.